Chanced upon 10 oil filters for $16.50(after coupon code) on aliexpress
These are the same oil filters used in yamaha spark 135/jupiter 135
The correct part number to use is 4d9-13440-00
Below are some photos taken comparing the original to the spark135 oil filter and also towards the aliexpress oil filter.
The aliexpress oil filter, sadly, had some quality control issues pertaining to the valve. 2/10 did not seal correctly. Im still figuring out if its a anti drain back valve or a bypass valve(i believe it to be this)
Its structure and filter media is similar to the "non original" oil filter that i bought. I will be using them.
Below are some photos.
I may not be active here. if needed, please contact me at hydher@gmail.com
Friday 10 May 2019
Revisiting the forks
The front forks are a vital component for the steering of the motorcycle, second to the steering cone.
Lucky for me in the history of this blog, i managed to dig up the fork level and viscosity needed. 15w, 255ml on each leg and 190mm from the top forks fully compressed with springs removed.
The oil seal retainer ring were too ridiculously corroded. Shops did not carry the part nor willing to order them for me. Lucky for me, i had a spare shadow ace750 fork lying around and the fitting of its retainer rings were spot on! phew.
I went with belray 15w fork oil 1L. Cost me $15 from lim ah boy.
Ybr250 spark plugs
The spark plug of a ybr250 is not available easily in singapore.
The proper part is
94700-00877(NGK DR8EA)
Commonly available is the d8ea
The problem is that without the R(resistor) there would or could produce electrical interference that could affect the cdi or any electrical components
Another option given would be DPR8EA
The problem is that being projected, the reach might be too deep. If a vehicle is not designed to take a projected spark plug, it could lead to engine problems.
Always avoid using iridium spark plugs on small displacements engine. It could lead to glazing of the piston. Proved many times and again.
I imported my spark plugs from the usa. Thanks to freight forwarding that makes it possible so cheaply.I ordered 8. Aplenty to last years to come.
The proper part is
94700-00877(NGK DR8EA)
Commonly available is the d8ea
The problem is that without the R(resistor) there would or could produce electrical interference that could affect the cdi or any electrical components
Another option given would be DPR8EA
The problem is that being projected, the reach might be too deep. If a vehicle is not designed to take a projected spark plug, it could lead to engine problems.
Always avoid using iridium spark plugs on small displacements engine. It could lead to glazing of the piston. Proved many times and again.
I imported my spark plugs from the usa. Thanks to freight forwarding that makes it possible so cheaply.I ordered 8. Aplenty to last years to come.
Paint job
What a sore resemblance of a school learner bike. Behold the red colour painted by aerosol cans without a proper clear coat. Red is colour that fades most rapidly due to the short wavelength that absorbs uv rays. Here are the photos of such a transformation. Enjoy
Orders
So the journey begins.
taobao.com for al my needed supplies.
Here are the things that i ordered
Air filter x 3
Oil filter x 11
oil filter o rings
Tapered head bearings
Chain and sprocket
Regina street touring x ring chain 428pitch 132links
clutch cable
clutch plate and disc w gasket
rear rack with givi simply rear box
fumoto valve
Lowering links
brake pads
fork seals
front fender extender
NGK spark plug DR8EA x 8
halogen headlight bulb
fz16 headlight bulb
taobao.com for al my needed supplies.
Here are the things that i ordered
Air filter x 3
Oil filter x 11
oil filter o rings
Tapered head bearings
Chain and sprocket
Regina street touring x ring chain 428pitch 132links
clutch cable
clutch plate and disc w gasket
rear rack with givi simply rear box
fumoto valve
Lowering links
brake pads
fork seals
front fender extender
NGK spark plug DR8EA x 8
halogen headlight bulb
fz16 headlight bulb
New beginnings
Sorry for the long absence. I purchased another ybr250. But this time around, it's a 2013 model. Seems similar to what I had bought before.
I needed a spare motorcycle with cheap spare parts. And when I saw this on sale at a good price, I grabbed it up.
Similar to the previous purchase, she had leaky forks, a worn clutch, loose head bearings and worn brake disc that was much expected. However the engine was silent which gained me the confidence to get her .
Here is the photo of the bike when first taken in by the shop
Here is the photo of the bike when first taken in by the shop
Subscribe to:
Posts (Atom)